Concrete finishing starts immediately after the concrete has been placed and consolidated. The initial step, screeding, involves leveling the concrete surface by removing excess material to flush it with the formwork's top. Following this, bull float or darby are employed to smooth the surface further, effectively lower high spots, fill low areas, and ensure larger aggregate particles are embedded within the concrete. This preparation is critical before the appearance of bleed water, as its presence can lead to scaling and dusting.
Once the surface is free from bleed water, the concrete is ready for its final finishing. This involves edging, which rounds off the slab's edges to prevent chipping; jointing, the creation of control, isolation, and construction joints to manage the concrete's natural movements and prevent unsightly cracking; and floating. The latter smooths out any imperfections left by the previous steps, slightly embeds the aggregate below the surface, and compacts the mortar at the surface for final finishing while allowing excess moisture to escape.
Concrete's final appearance and texture are achieved through various techniques, such as troweling to smooth and harden the surface, and brooming to roughen the surface. Additionally, patterns or exposed aggregate finishes can be applied to create decorative effects.
After consolidating the placed concrete, excess material is removed from the surface and flushed with the formwork's top using a screed.
Subsequently, using a bull float or darby, the high spots on the concrete surface are lowered, low spots are filled, and large aggregates are embedded in the concrete before bleed water rises to the surface.
Once the sheen from the bleed water on the surface disappears upon evaporation, it is ready for final finishing. This begins with edging, which involves rounding off the concrete's edges.
It is followed by jointing, where control, isolation, and construction joints are strategically located in the structure.
Next, a handheld float or power float is used to remove any surface imperfections resulting from edging and jointing, embed the aggregates slightly within the concrete, and remove the excess water, keeping the surface open.
Lastly, the finished surface may be textured by troweling to create a hard and smooth surface, brooming to make it rough and slip-resistant, washing the excess cement paste on the top to create an exposed look, or patterned by inserting divider strips.
繁體中文
